AW11 MR2
MR2 AW11
4AGE 16V
Year 1986-1989
Showing 1–12 of 71 results
-
4AGE 16V Engine Gasket Kit
€295.00Genuine Toyota Engine Gasket Set To Suit 4AGE 16V
BIGPORT BLUETOP (1983-1987)
TVIS
Cars: Ae82 AE86 AE92 AW11BIGPORT REDTOP (1987-1989)
TVIS
Car: AE92 AW11SMALLPORT REDTOP (1989-1992)
Also known as HI-Torque
Car: AE92This kit will also fit 4AGZE 16V engines, But will not have the gaskets for the supercharger (4AGZE 16V Gasket Kits are Discontinued by Toyota)
-
4age 16v Piston Set Bigport
€305.00Set of 4 pistons for 4age 16v Bigport engine
Includes piston rings and gudgeon pins
Available for standard bore 81mm or oversize 81.5mm
Both Gudgeon pin sizes 18mm and 20mm available
Compression ratio 9.4:1
-
4AGE Crank Trigger Pulley Kit 36-1
€299.00 – €379.00Toyota 4AGE Crankshaft Trigger wheel kit
A direct bolt on kit for your 4age.
Compatible for both 16v, 20v engines and all oem oil pump types.
RWD Version (rear wheel drive) AE86
Single row pulley for alternator / water pump belt
Can be used with original timing covers.
Only suitable for engines using RWD water pump and RWD alternator bracket.
Not suitable for use with AC or Power steering
FWD Version (front wheel drive) AE82 AE92 AE101 AE111 AW11 MR2
Twin row pulley can be used with AC and power steering
Only suitable for engines using fwd water pump and fwd alternator bracket.
Oil sump pan lip may need to be ground away on some engines to allow clearance for trigger wheel, trigger wheel may interfere with original timing cover
Kit includes the following:
Crankshaft pulley with built in 36-1 toothed wheel
Crank position sensor, Inductive Magneti Marelli 2 pin.
Crank position sensor plug
Crank position sensor bracket with all mounting bolts
*note: RWD and FWD 4age engine pulleys have a different offset so they can not be interchanged, otherwise the auxiliary belt will not line up. Please make sure to select the correct kit for your engine.
-
4AGE Crankshaft Bearing Set
€110.004age Crankshaft Bearing set
Includes the following:
-Main bearing set
-Big End Bearing set (available for 40mm or 42mm con rod journals)
-Trust Washer set
40mm con rod bearings are commonly found in 4AGE 16V 3 rib engines between Years 1983-1987
42mm con rod bearings are commonly found in 4AGE 7 rib engines 16V and 20V between Years 1987-2000
*please make sure to measure your crankshaft before purchase to ensure you purchase the correct bearings for your engine, these bearings are non returnable.
-
4AGE Silver Top 20V
€2,200.00 (excl. VAT €1,788.62)Toyota 4AGE 20V Silvertop engine
Removed from a JDM AE101 Automatic FX Levin
Sold as Seen
Please email us for s shipping Quote sales@flos.ie
-
AE86 Plastic Clip Assortment Kit
€43.73 (excl. VAT €35.55)AE86 Assortment plastic clip and screw kit
*Kit includes the following:
-Door card clips
-Sideskirt / bumper mounting clips
-Wing liner / mudguard clips
-Sidelight, indicator, quarter vent clips
-Boot carpet clips
-Interior plastic push clips
-Armrest clips
-Door rubber clips
-Interior screws, big and small type
-Wing liner and sideskirt screws
-Windscreen trim clips
and more…..*Assortment may vary
This kit has been made specifically for the AE86 by ourselves www.flos.ie and consists of the most commonly used clips and screws on any AE86
-
ARP Head Stud Set 4age 16v
€184.50 (excl. VAT €150.00)ARP Head Stud set for 4AGE 16v and 4AGZE 16v engines
Includes 16 studs, 16 washers and 16 nuts
This is the updated ARP kit has the stud with extra clearance for the distributor
-
ARP Main Bearing Stud / Bolt Kit 4AGE
€94.89 – €162.10Available as a stud or bolt kit
Suitable for both 16v and 20v engines -
AW11 Mr2 Polybushing Kit
€300.00 (excl. VAT €243.90)Bushing kit includes:
Front 18mm Anti-roll bushings
Front strut rod kit
Front control arm kit
Steering rack bushings
Rear strut rod kit
Rear control arm kit
-
Battery Pole Adaptors
€6.00 (excl. VAT €4.88)Battery pole adaptors
to convert your japanese type battery poles to the large poles
sold as a pair
-
BC Con Rods 4AGE
€795.00 (excl. VAT €646.34)Brian Crower Con Rods for 4age
To suit 16v and 20v 4age engines with 42mm big end and 20mm small end
* note some 4age blocks may require machine work to allow clearance for these rods
-
BC Racing Coilovers AW11
€1,137.75 (excl. VAT €925.00)BC Racing coilovers for Toyota MR2 AW11
Delivery time approx 2 weeks
Showing 1–12 of 71 results